Weider Pro 9400 English Manual - Page 7
Slide the Leg Press Seat Frame 79 onto the indi
View all Weider Pro 9400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Press a 2" Square Inner Cap (27) into the end of 4 the Top Frame (55). Press a 1 3/4" Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two Round Inner Caps (75) into the top of the crossbar. 27 Attach the Top Frame (55) to the Rear Upright (74) and the Leg Press Upright (56) with two 5/16" x 2 3/4" Bolts (11) and two 5/16" Nylon Locknuts (3). Attach the Top Frame (55) to the Front Upright (42) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Washers (8), and two 5/16" Nylon Locknuts (3). 11 Do not tighten the 5/16" Nylon Locknuts (3) yet. 55 11 75 8 44 3 44 Crossbar 56 74 3 42 5. Slide the Leg Press Seat Frame (79) onto the indicated 5/16" x 2 1/2" Carriage Bolts (1) in the Stabilizer (5). Hand tighten two 5/16" Nylon Locknuts (3) onto the Carriage Bolts. Attach the other end of the Leg Press Seat Frame (79) to the Leg Press Upright (56) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Washers (8), and two 5/16" Nylon Locknuts (3). Attach the Handle (82) to the Leg Press Seat Frame (79) with two 5/16" x 2 1/2" Carriage Bolts (1) and two 5/16" Nylon Locknuts (3). Tighten all 5/16" Nylon Locknuts (3) used in steps 1-5. 5 56 8 3 1 79 11 3 3 1 82 5 6. Set two Weight Bumpers (19) on the bracket on the Base (4) as shown. Set two Weight Bumpers on the bracket on the Stabilizer (5). Stack eight Weights (25) onto each set of Weight Bumpers (19). Be sure that the pin grooves are on the indicated side of each stack of Weights. Be careful not to tip either stack of Weights (25) until step 8 is complete. 6 25 19 Bracket Pin Grooves 25 5 Bracket 4 7 Pin Grooves 19