Weider Pro 9925 English Manual - Page 13
Leave enough room between the two Jam Nuts
View all Weider Pro 9925 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
27. Locate the Rear Cable (87)Ñthis is the shortest 27 Cable. Slide one end of the Rear Cable onto the 5/16Ó x 3Ó Bolt (92). Thread another 5/16Ó Nylon Jam Nut (91) onto the Bolt, but do not fully tighten it. Leave enough room between the two Jam Nuts for the Cable to pivot. 91 92 87 28. Attach a 3 1/2Ó Pulley (82) and two Pulley Covers 28 (94) to the upper hole in a Large ÒUÓ Bracket (84) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). Orient the wide tab on the Pulley Covers as shown. Make sure the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly. 29. Wrap the Rear Cable (87) around a 3 1/2Ó Pulley 29 (82). Attach the Pulley to the Top Frame (2) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). The Cable must be routed from the direction shown. 82 94 Wide Tab 42 42 87 94 50 84 2 50 82 87 30. Thread a 1/2Ó Plain Nut (83) onto the end of the Rear 30 Cable (87). Place a 3/8Ó x 1 1/4Ó Weight Spacer (32) and a 1/2Ó Washer (68) on top of the Weight Tube (25). Thread the end of the Rear Cable (87) into the upper end of the Weight Tube (25) until the Weight Spacer (32) touches the Weight Tube. Note: It is necessary to lift the Weight Tube (25) with the Top Weight (24) slightly to thread the Rear Cable (87) in place. 13 87 68 83 32 25 24