Weider Pro 9925 English Manual - Page 17

42. Remove the 3/8Ó Nylon Locknut (42) from the 42 3/8Ó x 5Ó Bolt (74) attached in step 40. Wrap the Press Cable (88) around a 3 1/2Ó Pulley (82) in the direction shown. Attach the Pulley and two Pulley Covers (94) to the Leg Press Arm (9) with the 3/8Ó x 5Ó Bolt, a 3/8Ó Washer (38) and the 3/8Ó Nylon Locknut. Orient the wide tab on the Pulley Covers as shown. 9 74 Wide Tab 82 42 38 94 88 43. Slide a 5/16Ó Washer (20) onto a 5/16Ó x 2 3/4Ó Bolt 43 (55). Insert the Bolt into the Front Seat Frame (8). Fully tighten a 5/16Ó Nylon Jam Nut (91) onto the Bolt. Slide the end of the Press Cable (88) onto the Bolt. Thread another 5/16Ó Nylon Jam Nut (91) onto the Bolt, but do not fully tighten it. Leave enough room between the two Jam Nuts for the Cable to pivot. 8 20 55 88 91 44. Locate the High Cable (85)Ñthis is the shortest remaining cable. Wrap the High Cable around a 3 1/2Ó Pulley (82) in the direction shown. Attach the Pulley and two Pulley Covers (94) to the Top Frame (2) with a 3/8Ó x 3 3/4Ó Bolt (76), two 3/8Ó Washers (38) and a 3/8Ó Nylon Jam Nut (43). Make sure the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the post. Orient the wide tab on the Pulley Covers as shown. 44 43 Post 2 82 38 Wide Tab 94 94 85 38 76 45. Wrap the High Cable (85) around a 3 1/2Ó Pulley (82) 45 in the direction shown. Attach the Pulley and two Pulley Covers (94) to the Top Frame (2) with a 3/8Ó x 3 3/4Ó Bolt (76), two 3/8Ó Washers (38) and a 3/8Ó Nylon Jam Nut (43). Orient the wide tab on the Pulley Covers as shown. 76 38 2 Wide Tab 82 94 85 38 43 17