Weider Pro 9925 English Manual - Page 6

3. Press a 2Ó Square Inner Cap (56) into the open end 3 of the Top Frame (2). Press a 2Ó Square Inner Cap (56) into each side of the Butterfly Frame (3). Press two 1Ó Round Inner Caps (70) into the top of the Butterfly Frame. Attach the Butterfly Frame (3) to the Top Frame (2) 2 with a 5/16Ó x 3Ó Bolt (92), a 5/16Ó Washer (20) and a 5/16Ó Nylon Jam Nut (91). Make sure the Bolt is on the side shown. Finish attaching the Butterfly Frame (3) to the Top Frame (2) with a 5/16Ó x 2 3/4Ó Bolt (55), a 5/16Ó Washer (20) and a 5/16Ó Nylon Locknut (40). 91 20 40 20 56 92 70 56 55 3 56 4. Slide the Front Seat Frame (8) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (49) in the Press Base (13). Hand tighten two 5/16Ó Nylon Locknuts (40) onto the Carriage Bolts. 4 55 20 Attach the other end of the Front Seat Frame (8) to the Leg Press Upright (4) with two 5/16Ó x 2 3/4Ó Bolts (55), two 5/16Ó Washers (20) and two 5/16Ó Nylon Locknuts (40). Press a 2Ó Square Inner Cap (56) into the Front Seat Frame (8). 5. Place the Rear Seat Frame (16) onto the indicated 5 5/16Ó x 2 1/4Ó Carriage Bolts (61) in the Weight Base (14). Hand tighten two 5/16Ó Nylon Locknuts (40) onto the Carriage Bolts. Attach the Rear Seat Frame (16) to the Ab Upright (1) with two 5/16Ó x 2 3/4Ó Bolts (55), two 5/16Ó Washers (20) and two 5/16Ó Nylon Locknuts (40). 16 40 40 4 13 49 55 55 40 1 8 56 40 20 40 20 14 61 6. Press a 2Ó Square Inner Cap (56) into each end of the Leg Lever (15). 6 42 Attach a Leg Press Bumper (53) to the indicated hole in the Rear Seat Frame (16) with a 1Ó Tap Screw (72). Lubricate a 3/8Ó x 3Ó Bolt (98). Attach the Leg Lever 15 (15) to the bracket on the Rear Seat Frame (16) with the Bolt and a 3/8Ó Nylon Locknut (42). 56 56 Lubricate 98 16 72 53 14 6