Weider Pro Lx7 English Manual - Page 10
Lubricate an M10 x 72mm Bolt 27. Attach the Leg
View all Weider Pro Lx7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10. Lubricate an M10 x 72mm Bolt (27). Attach the Leg 10 Lever (3) to the Front Leg (2) with the Bolt and an M10 Nylon Locknut (37). 37 3 2 27 Lubricate 11. Press four 19mm Round Caps (23) into the ends of the two Pad Tubes (17). Insert a Pad Tube (17) through the holes in the Leg Lever (3). Insert the remaining Pad Tube through the holes in the bracket on the Front Leg (2). Slide two Foam Pads (18) onto each Pad Tube (17). 11 18 23 17 23 3 18 2 12. Insert a Weight Rest (9) into one of the holes on each 12 Upright (6, 7). Make sure the shaft on the Weight Rest goes 9 through both sides of the Upright. 6 9 7 13. Press a Bushing (10) into the top and bottom of the Weight Carriage (48). Press a 2" Round Cap (25) into each end of the weight tube on the Weight Carriage (48). 13 31 25 Slide a Plastic Weight Stop (31) onto each end of the 48 weight tube as far as it will go. Press a Bushing (10) into the top (note the location of 10 the hole) of the Weight Stop (15). 15 10 10 25 31 10