Weslo Cadence 1000 Fm Uk Manual - Page 13
Time/Pace display
View all Weslo Cadence 1000 Fm manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Incline display-This display shows the incline level of the treadmill. Time/Pace display- When the manual mode is selected, this display will show the elapsed time and your pace (pace is mea- Indicator sured in minutes per mile or minutes per kilometer). The display will al- ternate between one number and the other every few seconds, as shown by the indicators in the display. When a speed program is selected, the display will show the time remaining in the program and your pace. Speed display-This display shows the speed of the walking belt. Note: The console can display speed and distance in either miles or kilometers. The letters "MPH" or "Km/H" will appear in the Speed display to show which unit of measurement is selected. To change the unit of measurement, first select the console's information mode by holding down the Stop button, inserting the key into the console, and then releasing the Stop button. An "E" for English miles or an "M" for metric kilometers will appear in the Incline display. Press the Speed increase button to change the unit of measurement. While the information mode is selected, the Distance display will show the total number of miles (or kilometers) that the walking belt has moved, and the Time/Pace display will show the total number of hours that the treadmill has been used. Important: If a "d" appears in the Speed display, the console is in the "demo" mode. This mode is intended to be used only while a treadmill is displayed in a store. While the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the displays will automatically light in a preset sequence. The buttons on the console will not operate. If a "d" appears, press the Speed decrease button so the "d" disappears. To exit the information mode at any time, remove the key from the console. 6 Measure your heart rate if desired. Before using the handgrip pulse sensor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean. Contacts To measure your heart rate, stand on the foot rails and hold the metal contacts-avoid moving your hands. When your pulse is detected, the heart symbol in the Fat/Cals/Pulse display will flash, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 13