Weslo Cadence 26.0 Instruction Manual - Page 10

9. Hold the Pulse Assembly (72) near the Handrail Bracket (70). Orient the Pulse Assembly so 9 that the indicated plastic post will fit into the hole in the Right Handrail (71). Connect the two Pulse Ground Wires (86) to the ground wires Post Pulse 86 Wires 72 on the Pulse Assembly. 71 69 Next, insert the wire harness on the Pulse Assembly (72) into the top of the Handrail Bracket (70) and pull it out of the side as shown. Set the Pulse Assembly (72) on the Handrails (69, 71). Insert the excess ground wire into the Handrails. Attach the Pulse Assembly with four #8 x 3/4" Screws (7). Be careful not to overtighten the Screws. Be careful not to pinch any wires. 7 70 7 Wire Harness 10. Hold the handrail assembly near the console assembly. Connect the wire harness extending from the handrail assembly to the wire harness extending from the console assembly. See the inset drawing in step 6. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. If YOU DO NOT CONNECT the connectors properly, the console may become damaged when you turn on the power. Set the Handrail Bracket (70) in the slot in the console assembly as you slide the ends of the Handrails (69, 71) onto the brackets on the Uprights (77, 78). Be careful not to pinch any wires. 10 Console Assembly Wire Harnesses Slot 69 Bracket 77 70 Handrail Assembly 71 78 Bracket 10