Weslo Cadence 26.0 Instruction Manual - Page 9

6. Have a second person hold the console assembly near the Right Upright (78). Connect the wire harness on the console assembly to the Upright Wire (74) as shown in the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. If YOU DO NOT CONNECT the connectors properly, the console may become damaged when you turn on the power. Remove the wire tie from the Upright Wire (74). 6 Console Assembly Wire Harness 78 74 Wire 74 Tie 7. Insert the wires into the Right Upright (78). Next, insert the brackets on the console assembly into the Right Upright and the Left Upright (77). Be careful not to pinch any wires. Attach the console assembly with four 5/16" x 3/4" Bolts (2) and four 5/16" Star Washers (5). Start all four Bolts, and then firmly tighten each of them. 7 2 5 78 Console Assembly 52 2 5 2 77 8. Set the Left Handrail (69) and the Right Handrail (71) on a level surface. 8 Attach the Handrails (69, 71) to the Handrail Bracket (70) with four 1/4" x 1 1/2" Bolts (3) and four 1/4" Nuts (4). See the lower drawing. Make sure that the Nuts sit inside the indicated square holes in the Handrails. Start all four Bolts, and then tighten each of them. 3 3 71 69 4 70 4 71 Square Holes 69 4 4 9