Weslo Cadence 800 Instruction Manual - Page 6

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex keys and your own phillips screwdriver adjustable spanners , and needlenose pliers . , two To identify the assembly hardware, see the PART IDENTIFICATION CHART in the center of this manual. WARNING: Do not plug in the power cord until the treadmill is completely assembled. 1. Orient the Base (46) so the holes for the four Base Pads (63) are on top. Attach the four Base Pads to the Base with the four 1" Tek Screws (5). Attach the two Wheels (68) to the Base (46) with two 2" Bolts (62) and two 3/8" Nuts (13) as shown. Do not overtighten the Bolts; the Wheels must be able to turn freely. 1 5 62 5 63 13 68 63 5 63 13 68 46 5 63 62 2. Identify the Right Handrail (59), which has a large hole in 2 one side. Have a second person hold the Base (46) in a vertical position, with the Base Pads (63) on the side 46 shown. Next, hold the Right Handrail against the Base so the large hole is in the position shown. Attach the Right 53 63 Handrail with two 2 1/2" Bolts (65) and two 5/16" Nuts (61), and a 2" Bolt (62) and a 3/8" Nut (13) as shown. Do not tighten the Bolts yet. Attach the Left Handrail (53) to the Base (46) in the 63 62 65 61 same way. Large Hole 13 63 59 65 6 HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, unplug the power cord. CAUTION: You must be able to safely lift 45 pounds (20 kg) to raise, lower or move the treadmill. 1. Hold the treadmill with your hands in the location shown by the arrow at the right. To decrease the possibility of injury, bend your legs and keep your back straight. As you raise the frame, make sure to lift with your legs rather than your back. Raise the frame about halfway to the vertical position. 2. Move your right hand to the position shown and hold the treadmill firmly. Using your left hand, pull the lock knob to the left and hold it. Raise the frame until it passes the lock pin. Slowly release the lock knob. Make sure that the frame is securely held by the lock pin. To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in temperatures above 30° C (85° F). HOW TO MOVE THE TREADMILL Before moving the treadmill, convert the treadmill to the storage position as described above. Make sure that the frame is securely held by the lock pin. 1. Hold the handrails, and place one foot against one of the wheels. 2. Tilt the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not move the treadmill over an uneven surface. 3. Place one foot against one of the wheels, and carefully lower the treadmill to the storage position. Handrails Wheel Frame Lock Knob Lock Pin Closed Base 15