Weslo Cadence 800 Instruction Manual - Page 7

3 Press the Start button or the Speed increase button to start the program. A moment after the button is pressed, the treadmill will automatically adjust to the first speed setting for the program. Hold the handrails and begin walking. Each program is divided into 30 one-minute periods. One speed setting is programmed for each period. Note: The same speed setting may be programmed for two or more consecutive periods. When only three seconds remain in the first period of the program, a series of tones will sound. If a different speed setting is programmed for the upcoming period, the Digital Speed zone of the display will flash. The treadmill will then automatically adjust to the speed setting for the second period. The program will continue until no time remains in the Time/Pace zone of the display. The walking belt will then slow to a stop. Note: If the speed setting for the current period is too high or too low, you can manually override the setting by pressing the Speed buttons. Important: When the current period of the program ends, the treadmill will automatically adjust to the speed setting for the next period. To stop the program, press the Stop button. The Time/Pace zone of the display will begin to flash. To restart the program, press the Start button or the Speed increase button. The walking belt will begin to move at 1 mph. When the next period of the programs begins, the walking belt will change to the speed setting for the next period. To end the program, press the Stop button, remove the key, and then reinsert the key. 4 Follow your progress with the display. See step 5 on page 12. 5 Measure your heart rate if desired. See step 7 on page 13. 6 When the program ends, remove the key from the console. When the program ends, see step 8 on page 13. 14 3. Hold a Frame Spacer (27) against the right side of the 3 Frame (79) as shown. Insert a 4" Bolt (70) into the indi- cated hole in the Frame Spacer and the Frame. Next, tighten a 3/4" Tek Screw (3) into the Frame Spacer and the Frame. Then, remove the Bolt. Repeat this step on the other side of the Frame. 79 27 3 70 4. Raise the Right Handrail (59) and the Left Handrail (not 4 shown) so the Base (46) is flat on the floor. Next, posti- tion the Handrails near the Frame (79). Locate the Wire Harness (60). Next, locate the long piece of tape in the large hole near the lower end of the Right Handrail (59). Wrap the end of the tape around the end of the Wire Harness as shown in drawing 4a. Then, tighten the included plastic tie securely around the tape and the Wire Harness as shown in drawing 4b. 79 59 46 Tape 60 4a 4b 60 Tape 60 Tie 5. With the help of a second person, lift and hold the Frame 5 (79) between the Right Handrail (59) and the Left Handrail (not shown). Finger tighten a 4" Bolt (70) with a 3/8" Washer (66) and a 3/8" Star Washer (29) through 59 the Right Handrail and the Frame Spacer (27) into the Frame. Do not tighten the Bolt yet. Repeat this step on the left side of the treadmill. 27 79 46 29 66 70 7