Weslo Cadence C32 Treadmill Canadian English Manual - Page 6
Wheel Bolts.
View all Weslo Cadence C32 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. With the help of a second person, lift the Frame (79) and attach the Base (46) to the Right Upright (62) with two Upright Bolts (65), two 3/8" Washers (66), and two 3/8" Nuts (61) as shown. Attach the Base (46) to the Left Upright (not shown) in the same way. Attach the Wheels (68) to the outside of the Base with two Wheel Bolts (67), 3/8" Washers (66), and 3/8" Nuts (61) (only right side shown). Do not overtighten the Wheel Bolts. 4. Raise the treadmill to the upright position. If there are plastic ties in the brackets on the Handrails (59), remove them. Hold a Handrail near the Right Upright (62). Insert the Wire Harness (60) up through the bracket on the Handrail and out of the round hole in the center of the Handrail. If necessary, use needlenose pliers to pull the Wire Harness out of the hole. Be careful not to damage the Wire Harness. Insert the brackets into the tops of the Left and Right Uprights (53, 62). Hand tighten four Handrail Bolts (42) with 1/4" Washers (38) into the Uprights (53, 62) and the Handrails (59). Remove the tape from the connectors at the end of the Wire Harness (60). 3 65 66 62 61 79 68 61 66 46 67 4 59 38 42 Connectors 60 42 38 59 53 Bracket 42 38 62 42 38 5. Set the Console Base (52) on the Handrails (45, 59). Thread four 3/4" Screws (2) into the Handrails and the Console Base. After you have started all four Screws, tighten the Screws until they are snug; do not overtighten the Screws. Firmly tighten but do not overtighten the bolts used in steps 2 through 4. 5 52 59 2 45 2 6. Insert the Battery Cover (54) up through the bottom of 6 the Console Base (52), with the hinges in the position shown. The Cover should pivot down, away from the Console Base. 52 Hinges 54 6