Weslo Cadence C32 Treadmill Canadian English Manual - Page 7

7. Hold the Console (57) near the Console Base (52). Touch the right Handrail (59) to discharge any static. Insert the Wire Harness (60) through the hole in the bottom of the Console Base (52). Locate the two wires in the Wire Harness (60) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 7a. Connect the other two wires in the Wire Harness to the back of the Console (57) in the locations shown by the arrows in drawing 7. The connectors should slide easily into the sockets and snap into place (see drawings 7b and 7c). If the connectors do not slide easily and snap into place, turn the connectors and then insert them. IF THE CONNECTORS ARE NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Make a loop with each of the indicated plastic ties around the Wire Harness (60). Securely tighten each plastic tie to prevent the Wire Harness from slipping. Cut off the ends of the plastic ties. 8. Set the Console (57) in the Console Base (52). Cover the Wire Harness (60) with the Wire Cover (11), and route the Wire Harness out of the hole in the side of the Wire Cover. Attach the Wire Cover to the back of the Console Base with two 3/4" Screws (2). Make sure that no wires are pinched before you attach the Console to the Console Base. Tighten four 3/4" Screws (2) into the Console Base (52) and the Console (57). Do not over tighten the Frame Bolts (70). 9. Attach the Storage Latch (48) to the Left Upright (53) with two 3/4" Screws (2). 7 57 52 60 7a 60 Ties 7b 59 Tabs 7c 8 59 52 11 57 45 60 2 22 9 53 2 48 10.Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 7