Weslo Cadence G 3.9 Instruction Manual - Page 6

PART IDENTIFICATION CHART Use the drawings below to identify small parts used for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see whether it is preattached. Extra parts may be included. M8 Washer (5)-6 M8 x 15mm Screw (3)-2 M8 x 20mm Screw (2)-4 M10 x 42mm Screw (1)-2 ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • Assembly requires the following tools: the included hex keys a Phillips screwdriver an adjustable wrench To avoid damaging parts, do not use power tools. 6