Weslo Cardiostride 3.0 Treadmill English Manual - Page 7

ASSEMBLY • To watch an assembly video, go to http://productvideo.co/ assembly/kmart/weslo or use your mobile phone or smartphone to read the QR code at the right. A reader application such as ShopSavvy must be installed on your mobile phone or smartphone. • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires the following tools: the included hex key one adjustable wrench To avoid damaging parts, do not use power tools. 1. Identify the Right Upright (10), which has a single hole in the indicated location. (Note: There is a wire inside of 1 the Left Upright [11].) Hold the Right Upright against the Base (12) as shown, and orient the Right Upright so that the two indicated holes are on the side shown. Attach the Right Upright (10) to the Base (12) with two 1 M8 x 50mm Bolts (1), two M8 Curved Washers (3), and two M8 Nylon Nuts (2) as shown. Make sure that the curved sides of the Washers are against the Base. Do not tighten the Nylon Nuts yet. 1 Attach the Left Upright (11) to the Base (12) in the same way. Make sure that the Left Upright is oriented so that the two indicated holes are on the side shown. Do not tighten the Nylon Nuts yet. 32 Holes 10 32 12 Hole 3 2 Holes 11 1 32 7