Weslo Cardiostride 3.0 Treadmill English Manual - Page 9

5. Align the hole on the Frame (14) with the hole in the Right Upright (10). Insert the Pin (15) into the holes in the Upright and the Frame. Make sure that the Pin is fully inserted. Then, attach a Spring Clip (20) on the end of the Pin. Look under the Frame (14) near the Left Upright (11). See drawing 5b. Locate the Reed Switch Clip (16) attached to the underside of the Frame. Insert the Reed Switch (17) into the Reed Switch Clip as shown. Next, locate the Magnet (18) on the Flywheel (19). Turn the Flywheel until the Magnet is aligned with the Reed Switch. Move the Reed Switch so that there is a 1/8" (3 mm) gap between the Reed Switch and the Magnet. 5a 11 5b 1/8 in. 14 18 17 16 19 10 14 20 15 6. Hold the Handrail (27) near the Left and Right Uprights (11, 10). Connect the Handrail Wire (21) to the Reed Switch Wire (22). Insert the Wires down into the Left Upright. Attach the Handrail (27) to the Uprights (11, 10) with four M8 x 15mm Screws (7) and four M8 Washers (8). Be careful not to pinch the Wires (21, 22). Do not fully tighten the Screws yet.  Place the treadmill in the storage position (see page 13). Center the Frame (not shown) between the Uprights (11, 10).  See step 1. Tighten the four M8 Nylon Nuts (2). Then, tighten the M8 x 15mm Screws (7). Lower the Frame (see page 13). View from below 6 78 21 22 11 27 10 8 7 9