Weslo Gym 750 Uk Manual - Page 12

22. Wrap the Short Cable (47) over a 90mm Pulley (34). Attach the Pulley and two Finger Guards 22 (35) to the Double "U"-bracket (42) with an M10 x 46mm Bolt (53) and an M10 Nylon Locknut (68). 53 35 35 42 68 47 34 23. Attach the end of the Short Cable (47) to the "U"bracket (43) with an M8 Washer (71) and an M8 Nylon Locknut (69). Note: Do not completely tighten the Locknut; it should be threaded onto the Cable so that two threads show past the Locknut, as shown in the inset drawing. 23 47 43 69 47 43 71 69 24. Locate the Low Cable (48). Attach the Cable 24 inside the Base (1) with an M10 x 65mm Bolt (55), two M10 Washers (70), two 10mm x 22mm Spacers (51), and an M10 Nylon Locknut (68). 55 70 48 25. Route the Low Cable (48) over a 90mm Pulley 25 (34). Attach the Pulley, a Cable Trap (36), and two Finger Guards (35) to the second set of holes from the bottom of the two Pulley Plates (44) with an M10 x 52mm Bolt (52) and an M10 Nylon Locknut (68). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 51 70 1 68 52 35 36 48 44 35 68 34 12