Weslo Momentum 750 English Manual - Page 11
Maintenance And Troubleshooting - replacement parts
View all Weslo Momentum 750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immediately. To clean the elliptical crosstrainer, use a damp cloth and a small amount of mild soap. Important: Keep liquids away from the console, place only a sealed water bottle in the water bottle holder, and keep the console out of direct sunlight. During storage, remove the batteries from the console. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, refer to step 4 on page 6 and remove the console from the upright. Next, refer to step 3 on page 6 and insert three batteries into the console. Reattach the console to the upright, being careful not to pinch the wires. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the Left Pedal Arm (11) and the Left Side Shield (3). 56 42 3 40 11 42 35 22 42 Remove the Pedal Arm Bolt Set (40), the M10 x 25mm Patch Screw (22), and the M10 Washer (35) from the Left Pedal Arm (11). Remove the Left Pedal Arm. Next, remove the two M4 x 25mm Screws (56) and the four M4 x 16mm Screws (42) from the Left Side Shield (3). Refer to the drawing below and locate the Reed Switch (53). Loosen, but do not remove, the indicated M4 x 16mm Screw (42). Slide the Reed Switch slightly toward or away from the Magnet (58) on the flywheel. Retighten the Screw. Turn the left Pedal Disc (15) for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the Left Side Shield (3) and the Left Pedal Arm (11). 58 53 15 42 HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even when the resistance is adjusted to the highest setting, the Drive Belt (19) may need to be adjusted. To adjust the Drive Belt, you must first remove the left side shield. Refer to HOW TO ADJUST THE REED SWITCH at the left and remove the left side shield. Next, loosen the M8 x 22mm Flat Head Screw (41) and turn the Idler Adjustment Bolt 19 (62) until the 41 Drive Belt (19) is tight. When the Drive Belt is tight, tighten the 62 Flat Head Screw. Reattach the left side shield. 11