Weslo Momentum 750 English Manual - Page 8
Pedal Arm to the left Handlebar Arm with the Bolt Set.
View all Weslo Momentum 750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
8. Apply a small amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal Arm (11) onto 8 the axle. Slide an M10 Washer (35) onto an M10 x 25mm Patch Screw (22), and tighten the Patch Screw into the axle. Next, hold the lower end of the left Handlebar Arm (5) inside of the bracket on the Left Pedal Arm (11). Apply grease to a Pedal Arm Bolt Set (40). Attach the Left 5 Pedal Arm to the left Handlebar Arm with the Bolt Set. Do not overtighten the Bolt Set; the Handlebar Arm must pivot freely. Grease Attach the Right Pedal Arm (not shown) to the right side of the elliptical crosstrainer in the same way. 16 Grease 40 Refer to step 5. Tighten the M10 x 66mm Button Bolts (48) in the Upright (2). Refer to step 6. Tighten the M8 x 38mm Button Bolts (50) in the Handlebar Arms (5). 40 11 22 35 9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. 8