Weslo Pursuit 102 Uk Manual - Page 4
Assembly
View all Weslo Pursuit 102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ASSEMBLY Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own adjustable spanner driver , and pliers . , Phillips screw- Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. M8 Nylon Locknut (10)-3 3/8" Nylon Locknut (33)-4 Curved Washer (42)-3 M8 Split Washer (55)-3 M8 Flat Washer (51)-3 M5 x 12mm Screw (49)-4 Ground Screw (27)-1 M8 x 15mm Button Screw (34)-3 3/8" x 68mm Carriage Bolt (30)-4 1. Set the Front Stabiliser (2) in front of the Frame (1), with the Wheels (23) on the side shown. Whilst another person lifts the front of the Frame slightly, attach the Front Stabiliser with two 3/8" x 68mm Carriage Bolts (30) and two 3/8" Nylon Locknuts (33). Make sure that the Front Stabiliser is turned so the Wheels are not touching the floor. 2. Whilst another person lifts the rear of the Frame (1) slightly, attach the Rear Stabiliser (6) with two 3/8" x 68mm Carriage Bolts (30) and two 3/8" Nylon Locknuts (33). 1 30 23 2 23 21 33 33 6 33 1 30 4