Weslo Pursuit E 25 Bike English Manual - Page 7

5. Attach the Seat (11) to the Seat Post (10) with four M8 Locknuts (9) and four M8 Spring 5 Washers (8). Note: The Locknuts and Spring Washers may be pre-attached to the Seat. Press the Frame Bushing (4) into the Frame (1). (Note: The Frame Bushing may be pre-assembled.) Next, insert the Seat Post (10) into the Frame. Align one of the holes in the Seat Post (10) with the hole in the Frame (1). Insert the Seat Knob (31) into the Frame and the Seat Post. Make sure that the Seat Knob is inserted into one of the holes in the Seat Post; do not insert the Seat Knob under the Seat Post. Then, tighten the Seat Knob into the Frame. 11 8 8 9 9 10 4 31 Hole 1 6. Identify the Right Pedal (22), which is marked with an "R." Remove only the Right Pedal Nut (47) and the Pedal Bushing (46) from the Right Pedal. Next, slide a 1/2" Flat Washer (44) onto the shaft of the Right Pedal (22), and insert the shaft into the right Pedal Arm (49). Then, orient the Pedal Bushing (46) as shown, slide it onto the shaft of the Right Pedal, and insert it into the Pedal Arm. Tighten the shaft of the Right Pedal (22) clockwise into the right arm of the Crank (20) as firmly as possible. Then, tighten the Right Pedal Nut (47) clockwise onto the shaft. Tighten the Right Pedal and the Right Pedal Nut as firmly as possible. Repeat this step to attach the Left Pedal (not shown), turning the Left Pedal and the Left Pedal Nut (not shown) counterclockwise. 6 47 46 44 22 49 20 7. Make sure that all parts are properly tightened before you use the exercise bike. Note: Some hardware may be left over after assembly is completed. Place a mat under the exercise bike to protect the floor or carpet from damage. 7