Weslo Pursuit E40 Bike English Manual - Page 5

ASSEMBLY Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench adjustable wrenches . , a phillips screwdriver , and two 1. While another person holds the Handlebar Post (14) 1 in the position shown, connect the Upper Wire Harness (10) to the Lower Wire Harness (11). Carefully slide the Handlebar Post onto the Frame (15). Be careful to avoid pinching the Wire Harnesses. Attach the Handlebar Post with three M8 x 27mm Button Screws (37) and three M8 Split Washers (49). 14 2. Identify the Front Stabilizer (17), which has a Wheel (25) on each end. Hold the Front Stabilizer (17) against the saddle on the front of the Frame (15). Attach the Front Stabilizer with two M8 x 90mm Carriage Bolts (30) and two M8 Nylon Locknuts (21). Attach the Rear Stabilizer (not shown) in the same manner. 3. The Console (7) requires four "D" batteries (not included); alkaline batteries are recommended. Press the tab on the battery cover, and lift off the battery cover. Insert four batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Reattach the battery cover. 49 37 10 11 37 49 37 2 30 15 25 17 25 3 Battery Cover 15 21 Tab Batteries 7 5