Westinghouse VR4090 User Guide - Page 27

42

Using Receiver

How Do I Adjust the LCD Display?

Using Remote Control unit under low light

When using Remote Control unit under low light, the back light of the

LCD display can be turned on.

•

Press and hold the

F.SHIFT

key for more than 2 sec-

onds.

The back light is turned on and off every 2 seconds of

holding.

If the

is blinked, the back light cannot be turned on

because the batteries are nearly exhausted.

Adjusting the contrast of LCD display

The contrast of the LCD display can be adjusted to improve the visibility.

1.

Press the Music key or Movie key to display “Menu”.

2.

Press the Menu (LCD function key 2) key.

3.

Press the Setup (LCD function key 2) key.

4.

Press the LCD cursor up/down (

/

) key to select “03. Contrast”,

then press the Enter key.

5.

Select the desired contrast with the LCD cursor up/down (

/

)

key. The previous menu re-appears in about 3 seconds after the above

operation.

1

2

3

4

5

6

7

8

9

10

11

12

+10

0

+100

/

8

/

7

1

1


43

Using Receiver

Adjusting the brightness of receiver

When the ambient light is low, for example in the night, the brightness of

the receiver’s display can be dimmed and LED indicators (DTS, 96k fs,

HDCD, DOLBY DIGITAL, MPEG and D.R.I.V.E. only) can be disabled.

•

Press the

F.SHIFT

=

LISTEN M

. (

DIMMER

)* keys. Each press of the

LISTEN M

. key switches the brightness as shown below.

1

Display/bright

Indicators/enabled

2

Display/dim

Indicators/enabled

3

Display/dim

Indicators/disabled

Selecting the display mode of receiver front panel

•

Press and hold the

LISTEN MODE

key on the receiver for more than

2 seconds.

The displayed information is switched every 2 seconds of holding the

key.

A:

Connected Device

Input Type

DVD

AUTO

B:

Input Terminal

Connected Device

VIDEO3 :

DVD

C:

Listen Mode

DOLBY DIGITAL

"Input Type" is displayed only when a selector with digital input is se-

lected.

When the input mode is

PHONO

,

TUNER

or

AV AUX

, the connected

device and listen mode are displayed alternately.


* When an operation is described as [

F.SHIFT

=

LISTEN M

. (DIMMER)

key], for example, press the

F.SHIFT

key and press the next key (the

LIS-

TEN M

. (DIMMER) key in this case) within 8 seconds.

Section	Page
VR-4090_4080_KRF-V7773D	1
Table of Contents	2
Chapter One: Moving Around	4
What’s on the Front Panel of Your Kenwood Audio-Video Receiver?	5
What’s on Remote Control unit?	7
LCD Indicators	9
How Do I Use Remote Control unit?	9
Chapter Two: Controlling the Receiver	10
How Do I Adjust the Sound?	10
Turning the Speakers On	10
Adjusting the Volume	11
Adjusting the Tone (Stereo mode only)	11
Adjusting the Loudness (Stereo mode only)	12
Adjusting Speaker Levels	13
Adjusting the Input Level	13
Muting Sound	14
Midnight Theater Function (Dolby Digital playback only)	14
What are Listen Modes?	14
Checking the listen mode during playback	15
To set the listen mode manually:	15
Examples of inputs with which switching is available	16
What are input modes?	16
Switching Input modes	17
Applying Digital Signal Processor (DSP) Effects	17
Setting a DSP effect	18
HDCDR and D.R.I.V.E. Effects	18
Headphone Operation	19
Selecting the Inputs	19
How Do I Operate Devices?	20
Operating a Television	20
Operating an AV Device	20
Operating a CD player	21
Single or Rotary CD Player	22
CD-R Recorder	22
Operating an MD Recorder or Cassette Deck	22
Playing an Analog Turntable	23
Monitoring a Video Camera or Playing an Additional VCR	23
Playing a Second CD player or Cassette Deck	23
Radio Tuning	23
RDS (Radio Data System) for U.K. Only	23
To tune into a radio station:	24
Storing RDS Station Automatically	24
To search for a specific type of music or radio program:	25
Recording	26
How Do I Adjust the LCD Display?	27
Using Remote Control unit under low light	27
Adjusting the contrast of LCD display	27
Adjusting the brightness of receiver	27
Selecting the display mode of receiver front panel	27
Executing Several Operations at Once (Macro function)	28
Registering a macro	28
Executing a macro	28
Chapter Three: Key Layout in Controlling Other Devices	29
Tuner Operation	29
CD Player Operation	30
CD-R Recorder Operation	30
MD Player Operation	31
DVD Player Operation	31
VCR Operation	32
LD Player Operation	32
TV Operation	33
Cable TV Player Operation	33
Satellite tuner Operation	34
DSS Operation	34
Chapter Four: Troubleshooting	35
Sound	36
I don’t hear any sound at all	36
Audio is not output only when a 96k fs compatible disc is played.	36
I can’t hear sound from one or more of the speakers, or the sound is abnormally low.	36
I can’t hear sound from my surround or center speakers	36
I can hear sound only from the center speaker when Dolby ProLogic or Dolby 3 Stereo is selected	36
Sound from one (or more) of my components is abnormally loudor soft	36
I can’t hear sound from some of my laser discs	37
There wasn’t any sound recorded on tapes made on my VCR or tape deck.	37
The initial sound is intermittent or non-existent when I start to play a Dolby Digital, DTS or MPEG source.	37
With a Dolby Digital program, the loud sounds aren’t very loud and the quiet sounds aren’t very quiet.	37
All I hear is loud static when I play DTS discs	37
I hear a hum when I select the PHONO input	37
Sound is intermittent	37
Video	37
I can’t see the program I’m playing on the TV There wasn’t any video output to my VCR when I recorded	37
Remote Control unit	37
My Remote Control unit is slow to respond.sometimes I have to press buttons or select commands several times	37
My Remote Control unit is not responding	37
The RF remote control function does not work.	38
Receiver/Tuner	38
My receiver won’t turn on and the STANDBY indicator is flashing front panel flashes red continually, or stays red for more than 1 second at a time.	38
I can’t receive a radio station	39
I can’t access any RDS (Radio Data System) functions	39
I’m getting a lot of static/interference	39
When I press a key to tune to a preset station, the receiver does not respond	39

Westinghouse VR4090 User Guide - Page 27

How Do I Adjust the LCD Display?

Page 27 highlights