Westinghouse VR4090 Setup Guide - Page 27
Connecting Your MD Recorder or Primary Tape Deck, continued
View all Westinghouse VR4090 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Connections Chapter One : Connecting Your Devices Connecting Your MD Recorder or Primary Tape Deck, continued Do not plug in the receiver to AC power until you have connected all your devices. This section focuses on the connections from your MD recorder or tape deck to the VR-4090/VR-4080/KRF-V7773D. Please refer to your MD recorder or tape deck's instructions for more detail about its connection jacks and capabilities. Each set of instructions in this section shows one of several possible variations on connecting your MD recorder or tape deck. For further assistance on optional configurations, contact the store where you purchased your MD recorder or tape deck. To Connect an MD Recorder: 1. Connect the audio cable from the MD recorder's Play OUT jacks to the receiver's MD/TAPE1 PLAY IN jacks as shown to the left. 2. Connect the audio cable from the MD recorder's Rec IN jacks to the receiver's MD/TAPE1 REC OUT jacks, as shown to the left. 3. (VR-4090 only:) When the MD recorder has digital jacks, connect digital (coaxial or optical) cables between the MD recorder's digital jacks and the receiver's MD/TAPE1 digital jacks, as shown to the left. (Although the figure shows both the coaxial cable connection and optical cable connection, use either connection in actual case.) When connecting a digital optical cable, remove the protect covers from the optical jacks. You only need to connect to the digital out jack if you will be recording from sources that are connected to a digital in jack, such as a CD or DVD player. 4. If you are connecting a Kenwood MD recorder, connect the system control cable from the MD recorder to the receiver. If you are connecting more than one Kenwood device with a system control cable, see "What if I Have Several Kenwood Devices (System Control Chaining)?" on page␣ 32 for more information. 5. Go to "Noting Your Devices" on page␣ 3 and note which jacks you used to connect your MD recorder. In addition, note the brand name and model number of the MD recorder. To Connect a Primary Tape Deck: 1. Connect the audio cable from the tape deck's Play OUT jacks to the receiver's MD/TAPE1 PLAY IN jacks as shown to the left. 2. Connect the audio cable from the tape deck's Rec IN jacks to the receiver's MD/TAPE1 REC OUT jacks as shown to the left. 3. If you are connecting a Kenwood tape deck with system control, connect the system control cable from the tape deck to the receiver. Be sure that the SL16/XS8 switch on the tape deck is set to SL16. If you are connecting more than one Kenwood device with a system control cable, see "What if I Have Several Kenwood Devices (System Control Chaining)?" on page␣ 32 for more information. 4. Go to "Noting Your Devices" on page␣ 3 and note which 21 jacks you used to connect your tape deck. In addition, note the brand name and model number of the tape deck. To Connect a Secondary Tape Deck See "Connecting Your Secondary CD Player or Tape Deck" on page␣ 22.