Westinghouse VR4090 Setup Guide - Page 45
Nothing, Enter, MD/Tape1, Kenwood
View all Westinghouse VR4090 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter Two : Setting Up the Remote Control Unit Remote Setup 01.CD1 02.MD/Tape1 03.CD-R Back Enter 5. See "Noting Your Devices" on page 3 to check the devices and the jacks to which they are connected. 6. Select a device connection jack name (CD1, MD/Tape1, etc.) using the or key, then press the Enter key (LCD function key 2). 01.CD 02.Tape 03.MD Back Enter 7. Select the device name connected to the jack (CD, Tape, etc.) using the or key, then press the Enter key. Kenwood Akai Alba Back Enter 8. Select the manufacturer name of the device using the or key, then press the Enter key. If the manufacturer name of the device is not listed, select "Nothing" and press the Enter key. In this case, the code can be programmed using the Learn function (see page 40). 01.0505 02.Nothing Back Enter 9. Select the setup code of the device (each device has a remote control identification number matching it) using the or key. • When the device is connected through a KENWOOD system control cord, select System. In this case, the remote control signal is sent to the receiver then to the device connected to it. 10. Press the AV.POWER key. Pressing the AV.POWER key causes Remote Control unit to transmit the signal turning on/off the device being set. The device is turned on if the selected setup code is correct. If it is not turned on, select another code and press the AV.POWER key again. In case it cannot be turned on by any code, see "If a device cannot be remote controlled with any code in the list, or to add remote control target functions...". Skip this step if System is selected in the setup code selection. 11. After ensuring that the setup code is correct, press the Enter key. 12. The display in step 3 re-appears. Set other devices by repeating steps 4 to 11 for each of them. To change a setup code: When a new device is purchased to replace the previously connected device, it is required to let Remote Control unit identify the new device as described below. 1. Connect the new device (see pages 4 to 32). 2. Perform the procedure in "Identifying Components for Remote Control Unit" on page 38 to select the jacks of the new device and enter a new setup code. The newly selected code replaced the previous code at the moment the Enter key is pressed to save the new code. To delete a setup code: When a device is disconnected and no replacing device is connected, it is required to remove the setup code from this Remote Control unit memory as described below. 1. Perform the procedure in "Identifying Components for 39 Remote Control Unit" on page 38 to select the jacks where the disconnected device was connected. 2. In step 7, select "Delete" by scrolling the device names. This makes Remote Control unit no longer identify the device. • If you select "Delete", the setup is deleted together with the input name. For example, once you delete VIDEO1 to VIDEO3, the VIDEO1 to VIDEO3 inputs are skipped even when they are selected. • If you select "No Type", the input name is displayed but only the registered device name is deleted.