Westinghouse VR4090 Setup Guide - Page 41

35

Remote Setup

Chapter Two : Setting Up the Remote Control Unit

Selecting the input:

Audio device:

Press the

MUSIC

key repeatedly. The input

names where audio devices are identified

by Remote Control unit will be shown on

the LCD screen.

1

CD1 :

2

MD/Tape1 :

3

Tuner :

4

CD-R :

5

Phono :

If an audio device which is connected to an

input is not identified by Remote Control

unit, the device name is skipped and not dis-

played.

Video device: Press the

MOVIE

key repeatedly. The input

names where video devices are identified by

Remote Control unit will be shown on the

LCD screen.

1

Video1 :

2

Video2 :

3

Video3 :

4

Video4 :

5

DVD/6ch :

6

AV AUX :

Remote Control unit is a new type of remote control unit

which receives information from the receiver and display it

on the LCD screen.

This section describes the basic operations of Remote Con-

trol unit.

Turning power on:

To turn the receiver on: Press the

SYS.POWER

key.

To turn the connected device on: Press the

AV. POWER

key.

(It is necessary to perform the procedure in “Identifying

Components for Remote Control Unit” to enable remote

control of AV devices.)

Adjusting the receiver’s volume:

Press the

VOL

(+/-) key repeatedly until the desired volume

is obtained.

Muting audio temporarily:

Press the

MUTE

key.

To resume the original volume, press the

MUTE key again or press one of the VOL

(+/-) keys.

Using the numeric keys:

When entering a figure directly for selecting a CD track num-

ber, etc., press the numeric keys as shown below.

To enter 5

:

To enter 25

:

or

:

2

+

-

VOL.

VOL.

Screen menu control operation

2WAY

LCD

REMOTE

CONTROL

UNIT

REC

REC

The contents of the func-

tion keys vary according to

current situations, and the

function names (Next,

Back, Enter, etc.) are shown

on the screen.

For details, see the descrip-

tion of each control opera-

tion.

Press to select an item by

scrolling the screen menu

up or down.

The selected item is dis-

played in an inverted color.

Basic Operation of Remote Control Unit

If a video device which is connected to an in-

put is not identified by Remote Control unit,

the device name is skipped and not displayed.

(VR-4080/KF-V7773D only)

Although

VIDEO4

is displayed in the initial

status, the receiver cannot be switched to se-

lect

VIDEO4

. The

VIDEO4

display will not

appear after the Remote Control unit has been

set up.

TV:

Press the

TV

key. The LCD screen shows TV if this is

registered in and identified by Remote Control unit.

01.IR

02.Surround

03.Contrast

Home

Enter

LCD

Function

key

1

LCD

Function

key

2

Westinghouse VR4090 Setup Guide - Page 41

Basic Operation of Remote Control Unit

Page 41 highlights