Whirlpool GB2SHTXTS User Guide - Page 7

Replace Doors and Hinges Style 1-Standard Door NOTE: Graphics may be reversed if door swing is reversed. Freezer drawer models 1. Replace the parts for the bottom hinge as shown. Tighten screws. NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working. 2. Assemble the parts for the top hinge as shown in Top Hinge graphic. Do not tighten screws completely. 3. Adjust the door so that the bottom of the refrigerator door is aligned with the top of the freezer drawer. Tighten all screws. Freezer door models 1. Replace the parts for the bottom hinge as shown. Tighten screws. Replace the freezer door. NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working. 2. Assemble the parts for the center hinge as shown in the Center Hinge graphic, and tighten all the screws. Replace the refrigerator door. 3. Assemble the parts for the top hinge as shown in the Top Hinge graphic. Do not tighten the screws completely. 4. Adjust the doors so that the bottom of the refrigerator door is aligned with the top of the freezer door. Tighten all screws. Style 2-French Doors 1. Assemble the parts for the top hinges as shown in Top Hinge graphic. Do not tighten the screws completely. 2. Replace the parts for the bottom hinges as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator doors. NOTE: Provide additional support for the refrigerator doors while the hinges are being moved. Do not depend on the door gasket magnets to hold the doors in place while you are working. 3. Align each door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws. 4. Reconnect the wiring plug on top of the left-hand side refrigerator door. 5. Replace the top hinge covers. Remove and Replace Freezer Drawer IM PORTANT: • Two people may be required to remove and replace the freezer drawer. • All graphics are included later in this section after "Final Steps." Remove Drawer Front 1. Open the freezer drawer to full extension. 2. Loosen the four screws attaching the drawer glides to the drawer front. See Drawer Front Removal graphic. NOTE: Loosen screws three to four turns. Keep the screws in the drawer front. 3. Lift drawer front upward and off the screws. See Drawer Front Removal graphic. Replace Drawer Front 1. Slide the drawer glides out of the freezer compartment. Insert the screws in the top of the drawer front into the slots in the drawer brackets. See Drawer Front Replacement graphic. 2. Pull the drawer brackets toward you to insert the two screws in the bottom of the drawer front into the brackets. See Drawer Front Replacement graphic. 3. Completely tighten the four screws. Final Steps 1. Check all holes to make sure that hole plugs and screws are in place. Reinstall top hinge cover as shown in Top Hinge graphic. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 2. Plug into a grounded 3 prong outlet. 3. Return all removable door parts to door and food to refrigerator.