Whirlpool LER5636PQ Installation Instructions - Page 4

PoweSr upplCy ord DirecWt ire FireHazard Usea new UL approved 30 amp power supply cord. Use a UL approved strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold). Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. 1. Disconnect power. 2. Remove the hold-down screw and terminal block cover. Fire Hazard Use 10 gauge solid copper wire. Use a UL approved strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold). Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. 3. Assemble a 3/4in. (1.9 cm) UL approved strain relief (UL marking on strain relief) into the hole below the terminal block opening, Tighten strain relief screws just enough to hold the two clamp sections together, Put power supply cord through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. 1. Terminal block cover 2. External ground connector 3. Center, silver-colored terminal-block screw 4. Hold-down screw location 5. Neutral grounding wire (green/yellow) 6. Hole below terminal block opening 4. Now complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) 4