Whirlpool LER5636PQ Installation Instructions - Page 6

4-wireconnection: Direct Wire IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 5 in. (12.7 cm) of outer covering from end of cable, leaving bare ground wire at 5 in. (12.7 cm). Cut 11_,in. (3.8 cm) from 3 remaining wires. Strip insulation back 1 in. (2.5 cm). Bend ends of wires into a hook shape. 4. Place the hooked end of the neutral wire (white or center wire) of power supply cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. Tighten screw. 3 4 5 r 2 When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze hooked end together and tighten screw. See example below. 1. Remove center terminal block screw. 2. Remove appliance ground wire (green with yellow stripes) from external ground connector screw. Fasten it under center, silver colored terminal block screw. 2 f 3 o ) 3 1. External ground connector- Dotted line shows position of NEUTRAL ground wire before being moved to center terminal block screw 2. Center silver-colored terminal block screw 3. Green/yellow wire of harness 3. Connect ground wire (green or bare) of power supply cable to external ground conductor screw. Tighten screw. 6 1. ¾ in (!.9 cm) UL-listed strain relief 2. Green or bare copper wire of power supply cord 3. External ground connector 4. Center silver-colored terminal block screw 5. Neutral wire (white or center wire) 6. Neutral grounding wire (green/yellow) 5. Place the hooked ends of the other power supply cable wires under the outer terminal block screws (hooks facing right). Squeeze hooked ends together. Tighten screws. !! !! 6. Tighten strain relief screws. 7. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 3-wire connection: Power Supply Cord Use where local codes permit connecting cabinet-ground conductor to neutral wire: 2 4 5 3 1.3-wire receptacle (NEMA type 10-30R) 2. 3-wire plug 3. Neutral prong 4. Spade terminals with up turned ends 5. _ in. (!.9 cm) UL approved strain relief 6. Ring terminals 7. Neutral (white or center wire) 7 6 6