Whirlpool UDT518SAHP Installation Instructions - Page 13
Utility Routing Channel Locaton
View all Whirlpool UDT518SAHP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
UTILITY ROUTING CHANNEL LOCATON 18. Water supply hose, power cord channel routing locations Fill valve Route water supply hose and electrical supply through the channels in the bottom of base as shown. Channels Junction box Hose Electical cord 20. Move dishwasher close to cabinet opening Water line Drain Cable Route the utilities through the holes in the cabinet, and pull the slack out at the same time as the dishwasher is pushed into the cabinet 21. Route power cord Route the water supply and electrical supply to the back of the unit through the bottom base channels provided. Secure utilites in channel using tape or wire ties. WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. If using a power cord, make sure to route the end through hole in cutout before sliding dishwasher into the cabinet opening. 22. Secure insulation blanket 19. Stand dishwasher upright Insulation blanket Secure blanket NOTE: Make sure insulation blanket is secured at both left and right rear corners before pushing into cabinet opening to keep the blanket from bunching up in a tight fitting cabinet. Using two or more people, stand the dishwasher up. NOTE: Do not install kick plate until instructed to do so. Dishwasher may fit tightly into cabinet opening. Do not remove insulation blanket-the blanket reduces the sound level. NOTE: Route water supply, drain hose, and power cord out the rear of the dishwasher. 13