Whirlpool UXT4230AD Installation Instructions - Page 8
Drill Electrical Opening, Prepare Range Hood Vents and, Mounting Tabs, Attach Vent Damper or
View all Whirlpool UXT4230AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
7. Drill Electrical Opening 9. Attach Vent Damper or Transition 3¹⁄₄" x 10" (8.3 x 25.4 cm) Rectangular Vent Damper Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked previously at the electrical strain relief. OPTIONAL: Using a ¹⁄₈" (3 mm) drill bit, drill pilot holes for the dots marked previously at each mounting tab at an approximate 45° angle in an upward direction. 8. Prepare Range Hood Vents and Mounting Tabs x2 F ■ Using (2) short Phillips head screws, install the 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular damper over the top or rear vent knockout removed in Step 8. NOTE: If the wall cap used has a damper and it interferes with the rectangular damper, remove the rectangular damper flap. 7" (17.8 cm) Round Vent Mounting Plate E D C B A A C B ■ Install Strain Relief Install a UL Listed/CSA Approved ¹⁄₂" (13 mm) strain relief (A). ■ Mounting Tabs Start a #8-18 x 4.2 x 16 mm) truss-head screw into the mounting tab (F) on each side of the range hood as shown in the inset. Insert the screws approximately 2 turns into the mounting tab holes. ■ Non-vent (Recirculating) Installations Using a #2 Phillips screwdriver remove the 2 screws and remove the top, front rectangular vent cover (E). Go to Step 12. ■ 3¹⁄₄" x 10" (8.3 x 25.4 cm) Rectangular Vent Installations For top vent installations, remove the top, rectangular vent knockout (C). OR For wall vent installations, remove the rear rectangular vent knockout (B). ■ 7" (17.8 cm) Round Vent Installations Remove both top knockouts (C and D). ■ Using (2) short Phillips head screws, install the 7" (17.8 cm) round vent mounting plate over the vent knockouts removed in Step 8. Position the wide flange (C) to the front. NOTE: An optional 7" (17.8 cm) round damper (A), Part Number W10355451, and a 7" (17.8 cm) round vent mounting plate (B), Part Number W10388168, are available as accessories. For information on ordering, see the "Assistance or Service" section. ■ If installing the optional round damper, position it over the round vent mounting plate. 8