Whirlpool UXT4230AD Installation Instructions - Page 9
Warning
View all Whirlpool UXT4230AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
10. Mount Range Hood Option 1 - Direct Wire Installations ■ Use a UL Listed/CSA Approved wire connector and connect the 2 white wires (A) together. ■ Use a UL Listed/CSA Approved wire connector and connect the 2 black wires (B) together. WARNING ■ Lift the range hood into place, positioning the rear slots over the mounting brackets. ■ Using a Phillips screwdriver, push on the screws that are started into the top mounting tabs and bend the tabs against the cabinet side walls. Attach the screws to the cabinet side walls. ■ For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. There must be enough wiring from the fused disconnect (or circuit breaker) box to make the connection in the range hood electrical terminal box. ■ Tighten the strain relief screws. NOTE: Do not reconnect power until the installation is complete. OPTIONAL: If you prefer, bend the rear tabs against the rear of the range hood and attach to the wall using #8-18 x 4.2 x 16 mm) truss-head screws. 11. Connect Vent System ■ Connect the ventwork to the range hood. Seal joints with vent clamps or duct tape to make secure and airtight. ■ Check that the back draft dampers work properly. 12. Make Electrical Connection A B C Fire Hazard Electrically ground the blower. Use copper wire. Connect ground wire to green ground screw in terminal box. Failure to do so can result in death, fire, or electrical shock. ■ Connect the green (or bare) ground wire (C) from the power supply to the green ground screw in the electrical box and tighten the screw securely. Reinstall the electrical box cover. Reconnect power. Option 2 - Power Cord Kit Installations For optional power cord kit installations, follow the instructions supplied with the power cord kit. See the "Assistance or Service" section for information on ordering. NOTE: Use only with range hood cord connection kits that have been investigated and found acceptable for use with this model range hood. 13. Complete the Installation ■ Install a 120V, 75W maximum, incandescent light bulb with E26 base. See "Replacing the Incandescent Light Bulb" in the "Range Hood Care" section. ■ If removed previously, replace the filter. See "Metal or Charcoal Grease Filter" in the "Range Hood Care" section. For vented installations: Install a metal filter. For non-vented (recirculating) installations: Install a charcoal filter. ■ Check the operation of the range hood fan and light. See the "Range Hood Use" section. If the range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown. Disconnect the power and check the wiring connections. NOTE: To get the most efficient use from your new range hood, read the "Range Hood Use" section. 9