Whirlpool UXT4230AYT Use & Care Guide - Page 12
Range Hood Care
View all Whirlpool UXT4230AYT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filter before operating hood. For non-vented (recirculating) installations: The charcoal filter is not washable. It should last up to 6 months with normal use. Exterior Surfaces: IMPORTANT: Do not use soap-filled scouring pads, abrasive cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths or paper towels. To avoid damage to the stainless steel, do not use cleaners that contain chlorine. Cleaning Method: ■ Rub in direction of grain to avoid scratching or damaging the surface. 1. Replace metal grease filter with a charcoal filter. For information on ordering, see the "Accessories" section. To replace filter: 1. Remove screw from the grease filter retainer. 2. Turn the grease filter retainer to release filter. 3. Reinstall the filter by placing the back edge in the channel at rear of hood. Push filter into place, turn the filter retainer to secure filter to range hood. 4. Replace screw in the grease filter retainer. ■ For stainless steal models, Stainless Steel Cleaner and Polish Part Number 31462A (not included): See "Assistance or Service" section to order. ■ Liquid detergent or all-purpose cleaner: Rinse with clean water and dry with soft, lint-free cloth. ■ Glass cleaner to remove fingerprints. Metal Grease Filter Replacing the Incandescent Light Bulb Turn off the range hood and allow the light bulb to cool. 1. Disconnect power. 2. Squeeze the plastic lens cover and remove it from the hood. AB For vented installations: 1. Remove screw from the grease filter retainer. 2. Turn the grease filter retainer to release filter. A A. Filter retainer 3. Wash metal filters as needed in dishwasher or hot detergent solution. 4. Reinstall the filter by placing the back edge in the channel at rear of hood. Push filter into place, turn the filter retainer to secure filter to range hood. 5. Replace screw in the grease filter retainer. A. Light bulb socket B. Lens cover 3. Screw light bulb into socket. 4. Replace lens cover by squeezing cover and inserting tabs into slots. 5. Reconnect power. If new light does not operate, make sure the lamp is inserted correctly before calling service. 12