Whirlpool WDF518SAHM Owners Manual - Page 7
Accessories
View all Whirlpool WDF518SAHM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
If you experience Noise Spotting/Filming Dishwasher does not clean completely Dishwasher does not drain Recommended solutions NOTE: Common noises: ■■ Surging sounds can occur periodically throughout the cycle while the dishwasher is draining. ■■ Normal water valve hissing may be heard periodically. ■■ A normal snap sound may be heard when the detergent dispenser opens during the cycle or when the door is opened at the end of the cycle. ■■ Improper installation will affect noise levels. Be sure the filters are properly installed. A thumping sound may be heard if items interfere with the wash arms. Readjust the dishware and resume the cycle. Liquid rinse aid is necessary for drying and to reduce spotting. Use the correct amount of detergent. Confirm that the cloudiness is removable by soaking the item in white vinegar for 5 minutes and dry the item. If the cloudiness disappears, it is due to hard water. Adjust the amount of detergent and rinse aid. See the "Dishwasher Care" section. If cloudiness on glass does not come clear, it is due to etching. Be sure the incoming water temperature is set at 120°F (49°C). Try using the Hi Temp Wash option. To remove spotting, run a vinegar rinse through the dishwasher. ■■ Wash and rinse the affected dishware and load into dishwasher. Remove all silverware and metal items. Put 2 cups (500 mL) of white vinegar in a 2-cup capacity measuring cup and place upright in the lower rack. Run a Normal cycle with the Heated Dry option turned off and no detergent. See the "Dishwasher Care" section in full User Instructions. Be sure the dishwasher is loaded correctly. Improper loading can greatly decrease the washing performance. See the "Operating Your Dishwasher" section. Check filter to ensure it is properly installed. Clean it if needed. See the "Filtration System" section in the full User Instructions for details. Select the proper cycle for the type of soils. The Heavy wash cycle can be used for tougher loads. Be sure the incoming water temperature is 120°F (49°C). Use the proper amount of fresh detergent. More detergent is needed for heavier-soiled loads and hard water conditions. Scrape food from dishes prior to loading (do not prerinse). Suds can come from: ■■ Using the incorrect type of detergent, such laundry detergent, hand soap, or dish detergent for hand-washing dishes. ■■ Not replacing the rinse aid dispenser cap after filling (or refilling) the rinse aid dispenser. ■■ Using an excessive amount of dishwasher detergent. Be sure the cycle has been completed (the Complete light is on). If it has not, you will need to resume the cycle by closing the door and pressing Start/Cancel. If dishwasher is connected to a food waste disposer, be sure the knockout plug has been removed from the disposer inlet. Check for kinks in the drain hose. Check for food obstructions in the drain or disposer. Check your house fuse or circuit breaker. ACCESSORIES Whirlpool Corporation also offers a variety of accessories for your dishwasher. In the U.S.A., visit www.whirlpool.com/accessories to order. In Canada, visit www.whirlpoolparts.ca to order. 7