Whirlpool WDP370PAHW Installation Guide - Page 3

Warning - dishwasher

Page 3 highlights

INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed: You must have: ■■ 120-volt, 60 Hz, AC-only, 15- or 20- amp, fused electrical supply ■■ Mating grounded electrical outlet We recommend: ■■ A time-delay fuse or circuit breaker ■■ A separate circuit INSTALLATION INSTRUCTIONS Pliers Small hammer Parts Supplied: ■■ Faucet Adapter Kit Part Number W10254672 ■■ 4 casters ■■ Literature package Make sure all these parts were included in the parts bag. Close and latch dishwasher door. See parts list for accessories available for your dishwasher. NOTE: Parts are available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See the "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer. LOCATION REQUIREMENTS ■■ Grounded electrical supply is required. ■■ Sink or laundry tub that can drain water at a minimum carry-away capacity of 7 gal. (26 L) per minute ■■ Top of sink or laundry tub that is at least 27" (68.6 cm) high and not higher than 48" (122 cm) from the bottom of dishwasher ■■ Floor support for dishwasher weight of 180 lbs (81.6 kg). ■■ Grounded electrical outlet ■■ Hot water faucet or hot and cold single-spout water faucet within 30" (76.2 cm) of the back of dishwasher ■■ 20-120 psi (103-827 kPa) water pressure WATER SUPPLY REQUIREMENTS ■■ A hot water line with 20-120 psi (138-862 kPa) water pressure can be verified by a licensed plumber. ■■ 120°F (49°C) water at dishwasher ELECTRICAL REQUIREMENTS Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/ NFPA 70 - latest edition, and all local codes and ordinances. A copy of the above code standards can be obtained from: National Fire Protection Association 1 Batterymarch Park Quincy, MA 02269 WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. CASTER INSTALLATION 1. Place 2 corner posts on floor behind dishwasher Corner post 2. Put dishwasher on its back Dishwasher door frame Grasp sides of dishwasher door frame and put dishwasher on its back. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

3
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
Tools Needed:
Pliers
Small hammer
Parts Supplied:
Faucet Adapter Kit Part Number W10254672
4 casters
Literature package
Make sure all these parts were included in the parts bag.
Close and latch dishwasher door. See parts list for accessories
available for your dishwasher.
NOTE:
Parts are available for purchase in plumbing supply
stores. Check local codes. Check existing electrical supply. See
the “Electrical Requirements” section. It is recommended that
electrical connections be made by a licensed electrical installer.
LOCATION REQUIREMENTS
Grounded electrical supply is required.
Sink or laundry tub that can drain water at a minimum
carry-away capacity of 7 gal. (26 L) per minute
Top of sink or laundry tub that is at least 27" (68.6 cm)
high and not higher than 48" (122 cm) from the bottom
of dishwasher
Floor support for dishwasher weight of 180 lbs (81.6 kg).
Grounded electrical outlet
Hot water faucet or hot and cold single-spout water faucet
within 30" (76.2 cm) of the back of dishwasher
20-120 psi (103-827 kPa) water pressure
WATER SUPPLY REQUIREMENTS
A hot water line with 20-120 psi (138-862 kPa) water
pressure can be verified by a licensed plumber.
120°F (49°C) water at dishwasher
ELECTRICAL REQUIREMENTS
Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code, ANSI/
NFPA 70 - latest edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
You must have:
120-volt, 60 Hz, AC-only, 15- or 20- amp, fused
electrical supply
Mating grounded electrical outlet
We recommend:
A time-delay fuse or circuit breaker
A separate circuit
INSTALLATION INSTRUCTIONS
CASTER INSTALLATION
1.
Place 2 corner posts on floor
behind dishwasher
Corner post
2.
Put dishwasher on its back
Dishwasher door frame
Grasp sides of dishwasher door frame and put dishwasher
on its back.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.