Whirlpool WDT730HAM Owners Manual - Page 12
Connect Water Line to Fill Valve, Measure cabinet opening, Adjust leveling legs
View all Whirlpool WDT730HAM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
11. Measure cabinet opening 12. Adjust leveling legs Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed. Be sure to measure the lowest point on the underside of the countertop and the highest point on the floor. Dishwasher Height Adjustment Chart Cabinet-opening Front legs height Rear legs height height A B 331/2" (851 mm) 3/8" (9.8 mm) Remove legs and spacers. 34" (864 mm) 7/8" (22 mm) 1" (25.4 mm) 341/2" (876 mm) 11/8" (28.8 mm) 11/4" (31.3 mm) Front legs - A Rear legs - B Refer to the "Dishwasher Height Adjustment Chart" for height of leveling legs needed for your cabinet opening. 13. Remove plastic rail cover A A. Plastic rail cover Remove and discard the plastic rail cover on each side of the dishwasher frame. To remove the plastic rail cover, push upward and back to unsnap it from the dishwasher frame. Connect Water Line to Fill Valve - For Copper Line, begin with step 14 - For Flexible Line, begin with step 16 14. Copper water line B Adjust both front and back leveling legs to the same height. NOTE: If the minimum cabinet opening height is less than 337/8" (860 mm), the rear leveling legs and spacers can be removed for additional clearance. This will allow the dishwasher to fit into a 331/2" (851 mm) high cabinet opening, but the dishwasher will be more difficult to move. (Measurements are approximate. Rear and front leveling legs are preset at the factory for 341/2" [876 mm].) If using copper tubing, measure overall length of copper tubing required to reach the water supply, cut to length, and attach with compression fittings. 12