Whirlpool WDT730HAM Owners Manual - Page 23
Option C: Waste disposer - with air gap, Option D: No waste disposer - with air gap
View all Whirlpool WDT730HAM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Option C: Waste disposer - with air gap G A F B E D C A. Screw-type clamps B. Disposer inlet C. Drain trap D. Drain hose E. Rubber hose connector F. Large drain hose clamp G. Air gap Helpful Tip: Remove disposer knockout plug. 1. Using a hammer and screwdriver, 1 knock plug into disposer. Option D: No waste disposer - with air gap A G F B E D C A. Screw-type clamps B. Waste tee C. Drain trap D. Drain hose E. Rubber hose connector F. Large drain hose clamp G. Air gap 1. Connect rubber end (A) of drain hose to 1 air gap and cut if needed. NOTE: Do not cut ribbed section. A 2 2. Use needle-nose pliers to remove plug. 2 2. Attach drain hose to air gap with large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screw- type clamp (not provided). 3. Use a rubber hose (not provided) with 3. Connect rubber end (A) of drain hose to 3 3 air gap and cut if needed. screw-type clamps (not provided) to connect from waste tee to air gap. NOTE: Do not cut ribbed section. A 4 4. Attach drain hose to air gap with large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screw- type clamp (not provided). 5. Use a rubber hose (not provided) with 5 screw-type clamps (not provided) to connect from air gap to disposer inlet. 23