Whirlpool WDT730HAMZ Installation Instructions - Page 22
Option A: Waste disposer - no air gap, Helpful Tip
View all Whirlpool WDT730HAMZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Option A: Waste disposer - no air gap A D C Option B: No waste disposer - no air gap D A C B A. Disposer inlet B. Drain trap C. Drain hose D. Large drain hose clamp Helpful Tip: Remove disposer knockout plug. 1. Using a hammer and screwdriver, 1 knock plug into disposer. 2. Use needle-nose pliers to remove plug. 2 3. Attach drain hose to disposer inlet with 3 large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. B A. Waste tee B. Drain trap C. Drain hose D. Large drain hose clamp 1. Fit rubber end (A) of drain hose to 1 waste tee and cut if needed. NOTE: Do not cut ribbed section. A 2 2. Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screw-type clamp (not provided). 22