Whirlpool WDT730HAMZ Installation Instructions - Page 7
Location Requirements, Copper Tubing, Screw-Type, Clamps, Optional, Longer, Drain, For Direct Wire
View all Whirlpool WDT730HAMZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Copper Tubing (3/8" [9.5 mm] O.D. suggested) or Flexible Braided Water Supply Line Kit. Screw-Type Clamps 11/2"-2" (38 mm - 50 mm) (3 maximum) Optional - Longer Drain Hose Maximum length 12 ft (3.7 m) NOTE: Must meet AHAM/ IAPMO test standards, fit 1" (25 mm) drain connection, and be resistant to heat and detergent. NOTE: Be sure to purchase only Whirlpool factory-certified parts and accessories for your appliance. Your installation may require additional parts. To order, refer to the contact information referenced in your Quick Start Guide. NOTE: If using a flexible braided hose, replace inlet hose after 5 years to reduce the risk of hose failure. Record hose installation or replacement dates on the hose for future reference. For Direct Wire For Power Cord Location Requirements Dishwasher must be fully enclosed (top, sides, back, and floor) upon installation. A side panel kit is available from your dealer for installing your dishwasher at the end of your cabinetry. An optional moisture barrier accessory is also available for installing underneath a wooden countertop. Check location where dishwasher will be installed. The location must provide: � Convenient access for loading and unloading dishes. Corner locations require a 2" (51 mm) minimum clearance between the side of the dishwasher door and the wall or cabinet. � Easy access to water, electricity, and drain: • Grounded electrical supply is required. • This dishwasher has a water-heating feature and also requires a connection to a hot water supply line. • Make sure pipes, wires, and drain hose are within the shaded area shown in the "Cabinet Opening Dimensions" section. • Do not run drain lines, water lines, or electrical wiring where they can interfere with or contact dishwasher motor or legs. • Shelter dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty. NOTE: If dishwasher will be left unused for a period of time or in a location where it may be subject to freezing, have it winterized by authorized service personnel. • If installed in new construction, flush the water supply line of debris before connecting it to the fill valve. If it is not flushed, debris from the water supply could plug the fill valve screen. � A square opening for proper operation and appearance. � The cabinet front to be perpendicular to floor. � A level floor. Helpful Hint: If floor at front of opening is not level with floor at rear of opening, shims may be used to level dishwasher. NOTE: To avoid shifting during dishwasher operation, shims must be securely attached to the floor. � The location where the dishwasher will be installed must provide clearance between motor and flooring. Motor should not touch the floor. � Do not install dishwasher over carpeted flooring. Cabinet Grommet Power Cord Kit For 11/2" (38 mm) hole in cabinet NOTE: Required for metal cabinets Kit typically includes power cord, metallic strain relief, grommet, and twist-on wire connectors (Straight: Whirlpool Part Number 4317824, 90°: Whirlpool Part Number W10278923RP). For proper installation, refer to the installation instructions provided with the kit. NOTE: Be sure to purchase only Whirlpool factory-certified parts and accessories for your appliance. Your installation may require additional parts. To order, refer to the contact information referenced in your Quick Start Guide. 7