Whirlpool WED94HEXW Owners Manual - Page 12

CYCLE STATUS INDICATORS Check Lint Screen Sensing Estimated Time Remaining Timed Dry Adjust Wet High Medium Low Extra Low Air Only Damp Cool Steam Static Done Wrinkle Down Reduce Shield 8 - 9 6 - 7 More Dry 4 - 5 Loud Normal Dry 2 - 3 Soft Less Dry 1 O Temperature Dryness Level Garment # Cycle Signal for auto cycles for refresh cycles 11-cycle model shown The Cycle Status Indicators show the progress of a cycle. Check Lint Screen The Check Lint Screen indicator will light when the drying cycle is complete as a reminder to clean the lint screen. Sensing The Sensing indicator will light during Eco Auto Cycles to indicate that the moisture sensor on the dryer is operating. This indicator will not light during Manual Cycles or options such as Wrinkle Shield™. Wet The load is still wet and/or the cycle just started. Damp This indicator shows that the load is partially dried and items that you may wish to hang up or iron while still damp may removed. Cool Down The dryer has finished drying with heat, and is now tumbling the load without heat to cool it down and reduce wrinkling. Steam (on some models) This indicator will light when the Steam function is active. NOTE: Steam is not available on all models or on all cycles. Static Reduce (on some models) This indicator will light when the Static Reduce function is active. NOTE: Static Reduce is not available on all models or on all cycles. Done This will indicate that the selected cycle has ended and the load may be removed from the dryer. If the Wrinkle Shield option has been selected, the dryer may continue to tumble the load, even if the Done indicator is lit. Wrinkle Shield™ This indicator will light if the Wrinkle Shield option has been selected and is running. The dryer will continue to tumble the load for up to 150 minutes after the cycle has ended. ADDITIONAL FEATURES USING THE DRYING RACK To obtain a drying rack for your dryer, follow the instructions included in your dryer drum. Remove and discard any packing material before use. Use the Drying Rack for items that you do not want to tumble dry, such as sweaters and tennis shoes. When you use the drying rack, the drum continues to turn, but the rack remains stationary. The drying rack is intended for use with the Manual Dry/ Timed Dry cycles only. The drying rack cannot be used with Automatic cycles. To use the drying rack: IMPORTANT: Do not remove the lint screen. 1. Open dryer door. 2. Align the two hooks on the front of the drying rack with the holes in the dryer door opening and press down fully into holes. Rest the rear support on the dryer back ledge. 3. Place wet items on top of the drying rack. Allow space around items for air to circulate. The drying rack does not move, but the drum will rotate; be sure to leave adequate clearance between items and the inside of the dryer drum. Make sure items do not hang over the edges or between drying rack grille. 4. Close the door. 5. Select a Timed Dry/Air Only, or Low Temperature cycle. Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Only setting. 6. When the cycle is selected, the Estimated Time Remaining display shows the default time. You can change the actual time in the cycle by increasing or decreasing the cycle time. 7. Start the dryer. NOTE: Check the lint screen and remove any lint accumulated from items dried on the drying rack after the cycle is finished. 12