Whirlpool WED94HEXW Owners Manual - Page 9

CYCLE GUIDE - MANUAL CYCLES Settings and options shown in bold are default settings for that cycle. Not all features and cycles are available on all models. Not all settings and options are available on each cycle. Adjusting drying CheckLintScreen Sensing time on Manual Cycles Wet Damp Cool Steam Static Done Wrinkle Estimated Time Remaining HigWh hen youDsowenlec8t- 9aRedMuceanuaSlhieCld ycle, the default Metdimiume appears in6t-h7 e display. Use the s and t ELoxtbwrauLottwonNMsoortrmeoaDlriDynrycre24a-- 35se or dSLooeuftdcrease the time in 1 Timed Dry Adjust AirmOnilny uteLeisns cDrryeme1nts. PreOss and hold to change the time in 5 minute increments. Temperature Dryness Level Garment # Cycle Signal for auto cycles for refresh cycles The maximum dry time is 100 minutes. Selecting the Drying Temperature A High heat setting may be used for drying heavyweight items such as towels and work clothes. A Low to Medium heat setting may be used for drying medium-weight items such as sheets, blouses, dresses, underwear, permanent press fabrics, and some knits. Use a no heat (air dry) setting for foam, rubber, plastic, or heatsensitive fabrics. Line dry bonded or laminated fabrics. NOTE: If you have questions about drying temperatures for various loads, refer to the care label directions. Items to dry: Drying Default Available Cycle: Temperature: Time: Options: Cycle Details: Small loads and Quick Dry sportswear High Medium Low Extra Low Air Only 13 Wrinkle Shield† Any load Timed Dry High 40 Wrinkle Shield† NOTE: Select Air Medium Only to dry foam, Low rubber, plastic, or Extra Low heat-sensitive Air Only fabrics. For small loads of 3-4 items. Use to dry items to a damp level for items that do not require an entire drying cycle. Select a drying temperature based on the type of fabrics in your load. If you are unsure of the temperature to select for a load, select the lower setting rather than the higher setting. † Or Wrinkle Shield with Steam (on some models). Wrinkle Shield with Steam is available only with High and Medium Drying Temperature settings. CYCLE GUIDE - STEAM CYCLES Settings and options shown in bold are default settings for that cycle. Not all settings and options are available on each cycle. Steam cycles are designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics. Items to refresh: Drying Default Available Cycle: Temperature: Time: Options: Shirts, blouses, Quick Refresh Medium 12 (15)* Wrinkle Shield† and slacks with Steam Static Reduce Mixed Loads Enhanced High 22 Wrinkle Shield† Touch Up Medium Static Reduce (on some models) Cycle Details: Use to reduce odors and light wrinkles. Select the number of garment to be refreshed (on some models). Do not add dryer sheets. Use to remove wrinkles, including from loads left in the dryer too long. Dry time will automatically adjust when the load size is sensed. Cycle run time cannot be manually adjusted, but Temperature is selectable. Do not add dryer sheets * 12 minutes on 11-cycle models. 15 minutes on 8-cycle models. † Or Wrinkle Shield with Steam (on some models). Wrinkle Shield with Steam is available only with High and Medium Drying Temperature settings. Load Size Recommendations For best results, follow the load size recommendations noted for each cycle. Small load: Fill the dryer drum with 3-4 items, not more than 1/4 full. Medium load: Fill the dryer drum up to about 1/2 full. Large load: Fill the dryer drum up to about 3/4 full. Do not overload. Items need to tumble freely. 9