Whirlpool WEE745H0FS Installation Guide - Page 12
Install Using Direct Wire
View all Whirlpool WEE745H0FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the ground-link screw and ground-link section. The ground wire must be attached over the ground-link section. 5. Use ³⁄₈" (1.0 cm) nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts. Install Using Direct Wire WARNING A F B C E A. 10-32 hex nut B. Ground-link screw C. Line 2 (red) wire D D. Green ground wire E. Neutral (white) wire F. Line 1 (black) wire 6. Connect line 2 (red) and line 1 (black) wires to the outer terminal block posts with 10-32 hex nuts. 7. Firmly tighten hex nuts. NOTE: For power supply cord replacement, use only a power cord rated at 250 volts minimum, 40- or 50-amps that is marked for use with nominal 1³⁄₈" (3.5 cm) diameter connection opening, with ring terminals and marked for use with ranges. 8. Tighten strain relief screws. IMPORTANT: Verify the tightness of the hex nuts. 9. Replace lower access cover. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these instructions can result in death, fire, or electrical shock. Direct Wire Strain Relief 1. Disconnect power. 2. Remove the lower access cover screws located on the back of the range. Pull the bottom of the cover toward you and out to remove cover from range. A B C A. Mounting tabs (3) B. Lower access cover C. Screws (2) 3. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block. 12