Whirlpool WET4024HW Instrucciones de instalacion - Page 30
Connect Inlet Hoses
View all Whirlpool WET4024HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Connect Inlet Hoses Washer must be connected to water faucets with new inlet hoses with flat washers (not provided). Do not use old hoses. NOTE: Both hoses must be attached and have water flowing to inlet valves. If you are only connecting to a cold water faucet, you must use a Y-adapter (not included). 1. Insert washer into each hose 3. Clear water lines Washer Coupling Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to prevent clogs. Water should run until clear. 4. Connect inlet hoses to washer Insert a new flat washer into each end of the inlet hoses (not provided). Firmly seat the washers in the couplings. 2. Connect inlet hoses to water faucets Attach hose to hot water faucet. Screw on coupling by hand until it is seated on washer. Use pliers to tighten couplings an additional two-thirds turn. Repeat this step with second hose for cold water faucet. IMPORTANT: Do not overtighten or use tape or sealants on valve when attaching to faucets or washer. Damage can result. HELPFUL TIP: Make note of which hose is connected to hot water to help in attaching hoses to washer correctly. In most standard configurations, hoses will cross over each other when attached correctly. Attach hot water hose to the bottom inlet valve. Screw coupling by hand until it is snug. Use pliers to tighten couplings an additional two-thirds turn. Repeat with cold water inlet valve (top valve). IMPORTANT: To reduce risk of hose failure, replace the hoses every 5 years. Record hose installation or replacement dates for future reference. n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found. 5. Move washer/dryer to final location Outer Access Panel (27" model shown) Inner Access Panel (27" models only) If you are working in a closet or recessed area: move the washer/dryer into its final location and remove cardboard from under washer/dryer. Remove the outer access panel by removing 2 (24" models) or 3 (27" models) Phillips-head screws and one bumper (27" models only), located at the top of the access panel. Remove inner access panel (27" models only) by removing clip, cover, and 2 screws. Set panels, screws, clip, inner access panel cover, and bumper aside. Complete hookup of water hoses and vent. Replace access panels upon completion of washer/dryer installation. 30