Whirlpool WFW94HEXW Use & Care Guide - Page 11

8. Select CYCLE 11. Setting a delayed start Door Locked Sensing FanFresh G Estimated Time Remaining S W W Delay Set Delay Start C Steam model shown Turn cycle knob to select your wash cycle. See "Cycle Guide" for details on cycle features. Not all options and settings are available on all cycles. 9. Adjust settings, if desired If you do not want to begin a cycle immediately, you may choose the DELAY START option. This will delay the start of the wash cycle by up to 16 hours on models with Steam, and 12 hours on non-Steam models. To set a delayed Start: 1. Press DELAY START s and t buttons to set the desired delay time. 2. Press START/PAUSE to set the delay. The delay countdown has started when the START/PAUSE light stops blinking. 12. Press and hold START/PAUSE to begin wash cycle Steam model shown The display will show the default settings for the selected cycle. If desired, press the button beneath each setting to adjust the Temperature, Soil Level, Spin Speed, and Cycle Signal. Adjusting the Soil Level will change the Estimated Time Remaining. Overloading, unbalanced loads, or excessive suds may also cause the washer to increase the cycle time. NOTE: Not all settings are available on all cycles. See "Cycle Guide" for available settings. 10. Select any additional options Steam model shown To add additional options to the cycle, such as the EcoBoost™ option, Deep Clean/Deep Clean with Steam (on some models), or Presoak, press the button for the desired options to add them to the selected cycle. NOTE: Not all options are available with all cycles. See "Cycle Guide" for available options. Press and hold the START/PAUSE button to start the wash cycle. To pause a cycle in progress, press the START/PAUSE button once, then press and hold again to continue the cycle. To cancel a cycle, press the POWER button. Once you press and hold START/PAUSE, you will hear the door lock, unlock, and lock again. The washer door will remain locked during the wash cycle. Unlocking the door to add garments: If you need to open the door to add 1 or 2 missed garments, you may do so while the "Add a Garment" light is lit. Press START/PAUSE once; the door will unlock once the washer movement has stopped. This may take several minutes. Then close door and press START/PAUSE again to restart the cycle. 11