Whirlpool WGD6200S Use and Care Manual - Page 18
Press END OF CYCLE SIGNAL until the desired volume
View all Whirlpool WGD6200S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
End of Cycle Signal The End of Cycle Signal produces an audible sound when the drying cycle is finished. Promptly removing clothes at the end of the cycle reduces wrinkling. Press END OF CYCLE SIGNAL until the desired volume (Loud, Soft or Off) is selected. [0_d S0ft Off ((4.b)) ENDOf CYCLE SIGNAL NOTE: When the WRINKLE SHIELD TM setting is selected and the End of Cycle Signal is on, a tone sounds every 5 minutes until the clothes are removed, or the WRINKLE SHIELD TM setting ends. To use the drying rack 1. Open dryer door. __ ..........A..... A. Front edge 2. Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure at the front of the dryer. You can change Automatic and Timed Cycles, Modifiers and Options any time before pressing Start. • Three short tones sound if an unavailable combination is selected. The last selection will not be accepted. Changing Cycles after pressing Start 1. Press PAUSE/CANCEL twice. 2. Select the desired cycle and options, 3. Press START. The dryer starts at the beginning of the new cycle. NOTE: If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off. Changing Modifiers and Options after pressing Start You can change an Option or Modifier anytime before the selected Option or Modifier begins. 1. Press PAUSE/CANCEL once. 2. Select the new Option and/or Modifiers. 3. Press START to continue the cycle. NOTE: If you happen to press PAUSE/CANCEL twice, the program clears and your dryer shuts down. Restart the selection process. Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack. A. Dryer rack front edge B. Dryer back panel 3. Put the wet items on top of the rack. Leave space between the items so air can reach all the surfaces. NOTE: Do not allow items to hang over the edge of the rack. 4, Close the door. 5. Press the POWER button. 6. Select a timed drying cycle and temperature (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Only temperature setting. You must select a time by pressing TIME ADJUST Up or Down. Reset time as needed to complete drying. Refer to the following table. Press (and hold) START button (about 1 second). 18