Whirlpool WGD7300DW Use & Care Guide - Page 11

TIMED DRY Cycle: When you select Timed Dry, the default time appears in the display. Touch "+" and "-" to increase or decrease the time in 1 minute increments. Touch and hold to change the time in 5 minute increments. The default temperature may be changed by touching Temperature until the desired dry temperature is lit. Steam Refresh Cycles (on some models): Select Steam Refresh to reduce odors and light wrinkles in dry loads consisting of wrinkle-free cotton, cotton-polyester blends, common knits, and synthetics. If you will be unable to remove a load immediately, touch Wrinkle Shield™ to add up to 150 minutes of periodic tumbling. You may select the + Steam setting to add a short steam cycle after 60 minutes to help smooth out wrinkles. 7. Touch and hold START/PAUSE to begin cycle Touch and hold START/PAUSE to begin the cycle. 5. Adjust cycle modifiers, if desired 8. Remove garments promptly after cycle is finished You may adjust different settings, depending on what you are drying and how your are going to dry the item. See the "Cycle Guide" for detailed information. NOTE: Not all options and modifiers are available with all cycles. Not all cycles are on all models. 6. Select any additional options Promptly remove garments after cycle has completed to reduce wrinkling. Changing the Automatic Cycle settings to increase or decrease drying time Add additional options such as Static Reduce, End Beep, and/or Wrinkle Shield (on some models) by touching that option. If you will be unable to remove the load promptly, select Wrinkle Shield™ before touching START/PAUSE. You may select the "+ Steam" setting (on some models) to add a short steam cycle after 60 minutes to help smooth out wrinkles. NOTE: Not all options and settings are available with all cycles. If all your loads on all Automatic Cycles are consistently less dry or more dry than you would like, you may change the default settings to increase or decrease the default dryness level. Your automatic drying settings can be adjusted to adapt to different installations, environmental conditions, or personal preference. This change is retained and will affect all of your Automatic Cycles, not just the current cycle/load. There are 5 drying settings, which are displayed using the time display: 0 Much wetter clothes, 30% less drying time. 1 Slightly wetter clothes, 15% less drying time. 2 Factory preset dryness level. 3 Slightly drier clothes, 15% more drying time. 4 Much drier clothes, 30% more drying time. To change the drying settings: NOTE: The settings cannot be changed while the dryer is running or paused. The dryer must be in standby mode (power is off) to adjust the default settings. 1. Before starting a cycle, touch and hold DRYNESS for 6 seconds. 2. Touch DRYNESS to select the dryness level shown in the time display: 0, 1, 2, 3, or 4. 3. Touch START/PAUSE to save the new dryness level setting. 11