Whirlpool WGD7300DW Use & Care Guide - Page 13
Whirlpool WGD7300DW Manual
View all Whirlpool WGD7300DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
NON-USE, STORAGE, AND MOVING CARE Steam models only: Install and store your dryer where it will not freeze. Because some water may stay in the hose, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it. SPECIAL INSTRUCTIONS FOR STEAM MODELS Water Inlet Hose Replace inlet hose and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hose if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hose, record the date of replacement. Non-Use or Storage Care Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should: 1. Unplug dryer or disconnect power. 2. Clean lint screen. See "Cleaning the Lint Screen." 3. Turn off the water supply to the dryer. This helps to avoid unintended flooding (due to a water pressure surge) while you are away. To Winterize the Dryer 1. Unplug dryer or disconnect power. 2. Shut off water faucet. 3. Disconnect water inlet hose from faucet and drain. Moving Care For power supply cord-connected dryers: 1. Unplug the power supply cord. 2. Gas models only: Close shut-off valve in gas supply line. 3. Gas models only: Disconnect gas supply line pipe and remove fittings attached to dryer pipe. 4. Gas models only: Cap the open fuel supply line. 5. Steam models only: Shut off water faucet. 6. Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately. 7. Make sure leveling legs are secure in dryer base. 8. Use tape to secure dryer door. To Use the Dryer Again 1. Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet. 2. Plug in dryer or reconnect power as described in the Installation Instructions. Changing the drum light (on some models) 1. Unplug dryer or disconnect power. 2. Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Using a 1/4" nut driver or socket wrench, remove the screw located in the lower righthand corner of the cover. Remove the cover. WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. For direct-wired dryers: 1. Disconnect power. 2. Disconnect wiring. 3. Steam models only: Shut off water faucet. 4. Steam models only: Disconnect the water inlet hose from faucet; then drain the hose. Transport hose separately. 5. Make sure leveling legs are secure in dryer base. 6. Use tape to secure dryer door. 3. Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw. 4. Plug into a grounded outlet or reconnect power. Reinstalling the Dryer Follow the Installation Instructions to locate, level, and connect the dryer. 13