Whirlpool WRT311FZBM Use & Care Guide - Page 22
Performance Data Sheet
View all Whirlpool WRT311FZBM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
PERFORMANCE DATA SHEET Water Filtration System Model P5WB12NL/P4RFWB12 Capacity 120 Gallons (455 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, and Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Live Cysts, Asbestos, Lead, Lindane, Toxaphene, Atrazine, and 2,4 - D. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53. Substance Reduction Aesthetic Effects Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Live Cysts† Asbestos Lead: @ pH 6.5 Lead: @ pH 8.5 Lindane Toxaphene Atrazine 2,4 - D NSF Reduction Requirements 50% reduction 85% reduction NSF Reduction Requirements 99.95% 99% 0.010 mg/L 0.010 mg/L 0.0002 mg/L 0.003 mg/L 0.003 mg/L 0.07 mg/L Average Influent 2.0 mg/L 7,300,000 #/mL Average Influent 160,000/L 87 MFL 0.160 mg/L 0.140 mg/L 0.0019 mg/L 0.014 mg/L 0.0094 mg/L 0.220 mg/L Influent Challenge Concentration 2.0 mg/L ± 10% At least 10,000 particles/mL Influent Challenge Concentration 50,000/L min. 107 to 108 fibers/L†† 0.15 mg/L ± 10% 0.15 mg/L ± 10% 0.002 mg/L ± 10% 0.015 mg/L ± 10% 0.009 mg/L ± 10% 0.210 mg/L ± 10% Maximum Effluent 0.20 mg/L 75,000 #/mL** Maximum Effluent 54/L† 0.17 MFL 0.001 mg/L 0.005 mg/L 0.00002 mg/L 0.001 mg/L 0.0005 mg/L 0.028 mg/L Minimum % Reduction 97 99 Minimum % Reduction 99.97 99 99.4 98.6 98.9 93 94.5 87.5 Average % Reduction 97.2 99.4 Average % Reduction 99.99 99 99.4 98.6 99 93 94.7 96.1 Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 120 gallons (455 liters). ■ It is important that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. Property damage can occur if all instructions are not followed. ■ Use replacement filter P4RRWB/P4RFWB12, part #W10295370. 2012 suggested retail price of $49.99 U.S.A./$59.99 Canada. Prices are subject to change without notice. Style 1 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. ■ The product is for cold water use only. ■ The water system must be installed in compliance with state and local laws and regulations. ■ Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. ■ Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. ■ Refer to the "Warranty" section for the Manufacturer's limited warranty. Style 2 - When the filter indicator changes from green to yellow, order a new filter. When the indicator changes from yellow to red, it is recommended that you replace the filter. Style 3 - When the filter indicator reads 10%, order a new filter. When the indicator reads 0%, it is recommended that you replace the filter. Application Guidelines/Water Supply Parameters Water Supply Water Pressure Water Temperature Service Flow Rate City or Well 30 - 120 psi (207 - 827 kPa) 33° - 100°F (0.6° - 37.8°C) 0.5 gpm (1.9 Lpm) @ 60 psi Style 4 - For models without a water dispenser, replace the disposable water filter every 6 months. The water filter indicator light will remind you when it is time to change the water filter. ■ After changing the water filter, flush the water system. For filtered ice only, make and discard three full containers of ice to prepare the water filter for use. ■ These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. *Class I particle size: >0.5 to