Whirlpool WRT311FZBM Use & Care Guide - Page 7
Reverse Center Hinge, Reverse Freezer Door - parts
View all Whirlpool WRT311FZBM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Reverse Doors and Hinges IMPORTANT: ■ Your model may have either handles that extend from the door or cup handles which are recessed into the doors. If your model has cup handles, disregard instructions pertaining to moving the handles to the opposite side. ■ See complete graphics later in these instructions. 4. Pull the lower part of the handle away from the door and push upward on the handle to release it from the shoulder screw. Keep all parts together. A B Round-Head Handle Screw Door Handle Screw Hole Plug Reverse Center Hinge 1. Remove the three screws (that match the exterior finish) from the handle side and use them to fill the holes created when the hinge screws were removed. A A. Screws matching exterior finish 2. Using the three hex head hinge screws, removed in Step 9, insert two screws halfway into the holes, leaving space to insert the Center Hinge. 3. Slide the center hinge, from the right, onto the screws, insert the third screw, and tighten all screws completely. NOTE: Make sure the washers are in place on both the top and bottom pins of the center hinge. C A. Freezer handle B. ¹⁄₄" Setscrew C. Flat-head handle screws 5. Using the plastic tool (provided), remove the brand badge from the freezer door by prying up the right-hand side and slowly peeling the badge away from the door, revealing the hole to mount the door handle. NOTES: ■ To avoid scratching the finish, do not use a sharp or metallic object to pry the brand badge from the door. ■ Rub a small amount of liquid dish soap over any adhesive residue with your fingers. Rinse the door with warm water and dry with a soft cloth. 6. Remove the shoulder screw from the left-hand side of the door and fasten it into the hole that was behind the brand badge. 7. Place the handle on the shoulder screw and push the handle toward the door until the mounting base is flush against the door. Tighten the setscrew. A B A A Hex head hinge screws B. Washers Reverse Freezer Door 1. Remove the three cabinet hole plugs from the top of the cabinet and place them in the hinge holes on the opposite side. A 2. Remove the two screws from the bottom of the freezer door handle. 3. Using the ¹⁄₈" hex key, loosen the setscrew attaching the top of the handle. A A. Setscrew 7