Whirlpool WTW2000HW Owners Manual - Page 11

5. Secure drain hose ((66 1¼mm⁄4""mm)) Drain hose Clamp Cabinet 1¼⁄4"" ((66 mmmm)) 8. Set TEMP to Tap Cold Place clamp over area marked "CLAMP." Release clamp. 6. Attach faucet kit adapter to faucet Washer Adapter Set the temperature setting on your washer to Tap Cold. Set the water temperature for the Wash cycle by adjusting the Hot and Cold water faucets. The Hot and Warm settings are inactive with Portable Installation. To test the water, press the red water-flow button on the hose connector. Water will be released when the button is pressed, allowing you to sample the temperature. NOTE: If desired, you can change the water temperature for the Rinse cycle by adjusting the Hot and Cold water faucets. Keep the temperature setting on your washer set at Tap Cold. Proper connection of your faucet adapter kit will allow hot and cold water to enter your washer properly. It also helps avoid water damage due to leaks. Attach the faucet adapter kit from the parts bag to your faucet. A standard faucet adapter and washer are supplied. Customized adapters are available from traditional plumbing supply sources. 7. Attach fill-and-drain hose connector to faucet 9. Plug into a grounded 3 prong outlet Red waterflow button Roll washer to sink area. It rolls and operates on wheels. The wheels do not roll from side to side. Be sure your washer is on a level floor to help avoid movement during spin. Attach fill-and-drain hose connector to a single-spout hot/cold water faucet. Move the locking collar down while lifting the connector until it snaps into place. 11