Whirlpool WTW2000HW Owners Manual - Page 12
Remove fill-and-drain hose, connector from faucet, Replace fill-and-drain hose on, storage bracket
View all Whirlpool WTW2000HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Disconnect Washer 1. Remove fill-and-drain hose connector from faucet Red water-flow button Turn off water faucets and unplug the power cord. Press the red water-flow button to release water pressure in the hose. Pull the locking collar down to remove the connector from the faucet. 2. Replace fill-and-drain hose on storage bracket Complete Installation Checklist ❑❑ Check electrical requirements. Be sure you have correct electrical supply and recommended grounding method. ❑❑ Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. ❑❑ Check that you have all of your tools. ❑❑ Check that shipping materials were completely removed from washer. ❑❑ Check that water faucets are on. ❑❑ Check for leaks around faucets and inlet hoses. NOTE: If the washer is attached to a faucet equipped with a spray hose, the constant water pressure may cause the spray hose to leak. To avoid possible failure, the spray hose should be disconnected or replaced with a high-pressure hose. ❑❑ Remove protective film from console and any tape remaining on washer. ❑❑ Check that washer is plugged into a grounded 3 prong outlet. ❑❑ Dispose of/recycle all packaging materials. ❑❑ Read "Washer Maintenance." ❑❑ To test and clean your washer, measure ½ of normal recommended amount of powdered or liquid detergent and pour it into washer basket or detergent dispenser (on some models). Close lid. Select any cycle. Start washer and allow to complete full cycle. Pour water out of the fill-and-drain hose connector. Place fill-anddrain hose on the plastic holder in the back of the washer. 12